Mercedes of the S-class W202

1993-2000 of release

Repair and operation of the car



Mercedes W202
+ 1.2. General information
+ 2. Maintenance
+ 3. Engines
+ 4. Lubrication system
+ 5. Cooling system
+ 6. Heating, ventilation
+ 7. System of ignition
+ 8. Fuel system
+ 9. Transmission
+ 10. Running gear
+ 11. Steering
+ 12. Brake system
+ 13. Body
- 14. Electric equipment
   14.1.2. Measuring devices
   14.1.3. Technology of measurements
   14.1.4. Checks of electric equipment
   14.1.5. Sound signal
   14.1.6. Replacements of safety locks
   + 14.1.7. Rechargeable battery
   + 14.1.8. Generator
   - 14.1.9. Starter
      14.1.9.1. Diagnostics of malfunctions of a starter
   14.1.10. Traction relay
   + 14.1.11. System of lighting
   14.1.12. Devices
   14.1.13. Dashboard
   14.1.14. Glow lamps on the dashboard
   14.1.15. Light switch
   14.1.16. Radio receiver
   + 14.1.17. Antenna
   14.1.18. Loudspeakers
   + 14.1.19. Rubber brushes of screen wipers
   14.1.20. Windscreen washer jets
   14.1.21. The washing nozzles of headlights
   14.1.22. Screen wiper and its engine
   14.1.23. Protect the car
   14.1.24. Anticreeping "immunodeficiency"
   14.1.25. Why headlights grow dull
   14.1.26. Galogenka
+ 14.2. Electrical circuitries





14.1.9. Starter

GENERAL INFORMATION

The internal combustion engine starts the small electric motor – a starter. That in general it was possible to start the engine, the starter has to disperse to rotation frequency not less than 300 rpm. It is feasible only if the starter works normally, and the rechargeable battery is rather charged.

The starter consists of a case of the drive, the case of poles and the collector case. The anchor and a collector, and also the holder of coal brushes are installed in the case of poles and the collector case on bearings. In the holder of brushes there are coal brushes which slowly, but constantly wear out. At high wear of coal brushes the starter cannot normally work more.

In a forward case of the drive the gear drive is installed. When after inclusion of ignition the starter receives tension, by means of the traction relay installed on the starter case, the gear wheel is displaced on an abrupt carving to a gear rim of a flywheel of the engine. As soon as the gear wheel reaches the limiter on the running screw, it with power short circuit connects to a flywheel. Now the starter of the engine can be established on the necessary starting frequency of rotation. If the engine of the car takes dispersal, the gear wheel accelerates the engine, therefore, it some time rotates quicker, than the engine of a starter also leaves gearing thanks to what connection of a gear wheel with the internal combustion engine is liquidated. As start of the engine requires high consumption of current, within maintenance it is necessary to pay attention to perfect connection of wires. Clear the correlated connections of wires and grease them with antiacid polar lubricant.

Removal

1. Plug 30 wire
2. Plug 50 wire
3. Bolts
4, 6. Holder
5. The holder (only at petrol engines)
7. Spring clip / holder
M1. Starter

PERFORMANCE ORDER
1. Disconnect the wire (–) connecting it a pole to the car case from the plug of the rechargeable battery.
Prevention

Disconnect this wire from the battery only at the switched-off ignition, otherwise the actuation device of system of injection of fuel can be damaged. Before a detachment of wires from plugs of the rechargeable battery it is also necessary to read recommendations in appropriate section.


2. Raise the car ahead. If is available, remove the lower cover of a motor compartment.
3. Disconnect a wire from the plug 30 (1) and the plug 50 (2) on the traction relay.
4. Remove brackets from 4 to 7 for fixing of wires. At cars with the diesel engine the bracket (5) for fixing of wires is absent.
5. the 6-cylinder engine with the automatic transmission: unscrew the back bearing of a shaft of the engine on a frame.
6. Unscrew on a starter flange bolts (3).
7. Extend a starter down. At the 6-cylinder engine slightly turn previously steering wheel to the left.

Installation

PERFORMANCE ORDER
1. Establish a starter and hardly tighten bolts with m 40 N.' moment. At the 6-cylinder engine establish steering for driving directly again.
2. Screw a wire on the plug 30 with m 15 N.' moment, on the plug 50 with m 5 N.' moment.
3. Establish brackets from 4 to 7 for fixing of wires.
4. Establish the lower cover of a motor compartment.
5. Connect a weight(s) wire to the plug of the rechargeable battery. Determine time on hours, and also enter an anticreeping code for radio.