Mercedes of the S-class W202

1993-2000 of release

Repair and operation of the car



Mercedes W202
+ 1.2. General information
- 2. Maintenance
   + 2.1.1. Engine
   2.2. In addition through each 60 000 km of a run
   2.3. Every 2 year
   2.4. Every 3-4 year
   + 2.5. Works on maintenance
   + 2.6. Care of the car
   2.7. Start of the engine from the auxiliary accumulator
   2.8. Towage of the car
   2.9. Raising of the car
   2.10. The tools used to maintenance
+ 3. Engines
+ 4. Lubrication system
+ 5. Cooling system
+ 6. Heating, ventilation
+ 7. System of ignition
+ 8. Fuel system
+ 9. Transmission
+ 10. Running gear
+ 11. Steering
+ 12. Brake system
+ 13. Body
+ 14. Electric equipment
+ 14.2. Electrical circuitries





2.9. Raising of the car

GENERAL INFORMATION

Points of rise and support: onboard automobile jack


The car elevator in a workshop


The automobile elevator with a platform, false goats and the elevator of the car in a workshop


Prevention

At work under the car if there is no automobile elevator with a platform, establish it on two or four steady goats. Do not work at all under the car if it is insufficiently insured or if it is propped up only by an automobile jack. It is life-threatening!

Raise the car only in not loaded state.

Using rubber or wooden laying, it is possible to avoid when raising the car of damage of the basis of its body. It is impossible to raise or prop up the car under the engine or under the transmission at all.

Record wedges the wheels standing on a basic surface against their rolling forward or back. Do not rely on the parking brake system as at some repair work it has to be stirred up.

Lift the car only on a plain rigid surface.

Put the car on a false trestle so that respectively one his leg sideways stuck out outside.


Working with the screw-driver as the lever, remove the protection cover on a landing opening for an automobile jack.

Carefully implant an adjusting finger of an automobile jack into a plug-in pipe of a longeron.

Establish an automobile jack vertically even at a bias.

Raise the forward bridge ahead, having installed the elevator on a cross-piece of a frame (6) (see rice. The car elevator in a workshop).

Raise the car behind, having installed the elevator on a crosspiece of the back bridge (see rice. The car elevator in a workshop).

Reference points ahead and behind are below plug-in pipes for an onboard automobile jack and are supplied with ebonite shock-absorbers (see rice. The automobile elevator with a platform, false goats and the elevator of the car in a workshop).


Prevention

Points of support on longerons can be used also for side rise with use of the elevator of the car in a workshop. At the same time establish an automobile jack under ebonite shock-absorbers.