Mercedes of the S-class W202

1993-2000 of release

Repair and operation of the car



Mercedes W202
- 1.2. General information
   1.3. Maintenance
   1.4. Keys
   1.5. Doors
   1.6. Seats
   + 1.7. Security systems
   + 1.8. Equipment of salon
   - 1.9. Driving
      1.9.2. Start-off about places and gear shifting
      1.9.3. Installation of the lever of the choice (DB)
      1.9.4. Switch of the choice of the mode of the movement (DB)
      1.9.5. Traffic control
      1.9.6. Cruise control
      1.9.7. Consumption of oil and fuel
   1.10. Engine cowl
   1.11. Ventilation block, conditioner
   1.12. Several councils upon purchase of the car
   1.13. The changed numbers
   1.14. Purchase of the old car
   1.15. Durability of the car
   1.16. About parallelism of bridges of the car and trailer
   + 1.17. Preparation of the car for winter
+ 2. Maintenance
+ 3. Engines
+ 4. Lubrication system
+ 5. Cooling system
+ 6. Heating, ventilation
+ 7. System of ignition
+ 8. Fuel system
+ 9. Transmission
+ 10. Running gear
+ 11. Steering
+ 12. Brake system
+ 13. Body
+ 14. Electric equipment
+ 14.2. Electrical circuitries






1.9.2. Start-off about places and gear shifting

GENERAL INFORMATION

Having started check a brake. Quickly warm up the engine. After achievement of the necessary temperature of the engine check steering. In order to avoid damage of a back axis, at start-off from the place on the slippery surface of the road completely avoid long scrolling of driving wheels.

Mechanical transmission


Switching to the reverse gear is carried out at the standing car. For this purpose it is necessary to raise the switching lever.

Do not exceed the most admissible speeds in separate transfers (see marking on a speedometer).


Prevention

Leaving the car, put on 1 or the reverse gear, put on the emergency brake.


Automatic transmission


Separate transfers join automatically, depending on:

  – provisions of the lever;
  – car speeds;
  – provisions of a pedal of an accelerator.


Prevention

Leaving the car or performing any works in the car with the working engine, to install the emergency brake, and the choice lever in situation "P".

Start-off

Install the choice lever on desirable situation only in the single mode of the engine, involving at the same time the braking mode. At once at start-off release a brake, otherwise there is a danger that the car will start prematurely.

Installation of a pedal of an accelerator

It is not enough gas = operation = insignificant dispersal earlier.

Late operation = strong dispersal is a lot of gas =.

It is too much gas (the pedal of an accelerator is drowned below a point of full gas) = the return switching to lower transfer = the maximum dispersal.






Скорее посмотрите: цены на нефть по годам